Spirit UltraMic Plus User Manual

Featuring

BAND INSTRUMENTS/VOCALSPage 10Live Monitor with In-Ear Monitoring

Page 11Theatre

Page 12FOH Console

Page 13FOH Console with Subgrouping

Page 14333331111122222+48V+48V+48V+48VMICINPUTSPLITSPLIT OUTPUT(Internal Link)Link - GroundedNo Link - Ground LiftTIP: SENDRING: RETURNHOUSEMICS

BalancedUnbalancedInsert Leads’Y’ Leads (Unbalanced)Lamp Connections’Y’ Leads (Balanced)Headphone SplitterPage 15Connecting Leads

Control Position SheetYou may freely copy this page to mark control positions to assist in resetting the desk between performances.

Page 17INPUTSMONITOR 2 CONSOLETypical Starting Out Control Positions

Page 18SpecificationsNoise Measured RMS, 22Hz to 22kHz Bandwidth. Inputs at unity gain and terminated 150WOutput Noise 24 inputs routed, sends down, m

A Harman International CompanyPart No: ZM0192

Page 2SAFETY PRECAUTIONSThe SPIRIT MONITOR 2 mixer must only be connectedthrough the Power Supply supplied.The wires in the mains lead are coloured in

Page 3INPUTS24Connecting Up

USING MONITOR 2Mono Input ChannelXLR InputThe UltraMic Plus padless input preamp is designed to accept BALANCED orUNBALANCED signals at a wide range o

Page 5MONITOR SENDSThese controls route the input channel signal to any one or more Monitorbusses and the associated Monitor Outputs, allowing a numb

Page 69108761234511OUTPUT SECTIONMONITOR OUTPUTSThese outputs provide summing of the corresponding input channelmonitor sends, and drive XLR-type outp

Page 7MASTER SECTIONWEDGE SOURCEThe Engineers Wedge outputs are normally fed from a mix of the MNTRfeeds from outputs 1-12. The pre-fade wedge signa

Page 8Setting Up & TroubleshootingInitial Set UpOnce you have connected up your system (see thesections on connection and wiring earlier in this m

Page 9BAND INSTRUMENTS/VOCALSLive Monitor with EffectsAPPLICATIONS