Spirit FOLIO SX mixer User Manual download pdf (Page 12)

Page 11

AUX SEND 2

This is normally POST-FADE, and would typically be used as an effects send, but may

be switched globally to PRE-FADE using the POST/PRE switch on the Master section,

providing a second foldback or monitor send if required.

AUX SEND 3

This is always POST-FADE for effects sends, external submix (or for Centre Voice

cluster or mono Tape mix).

9 PAN

This control sets the amount of the channel signal feeding the Right and Left MIX or

SUB buses, allowing you to move the source smoothly across the stereo image. When

the control is turned fully right or left you are able to route the signal at unity gain to

either left or right outputs individually.

10 ON

All outputs from the channel except inserts are muted when the ON switch is

released and enabled when the switch is down, allowing levels to be pre-set before the

before the signal is required.

11 MIX / SUB

The channel signal may be routed to either the main MIX (switch UP) or SUB buses

(switch DOWN). The left/right balance is set by the PAN control (see above) allowing

the signal to be sent proportionately to any of the buses.

12 FADER

The 100mm FADER, with a custom-designed law to give even smoother control of

the overall signal level in the channel strip, allows precise balancing of the various source

signals being mixed to the Master Section. You get most control when the input SENSI-

TIVITY is set up correctly, giving full travel on the fader. See the `Initial Set Up section

on page 16 for help in setting a suitable signal level.

13 DIRECT PRE/POST

See Direct Output (1) and Advanced Features on page 18 for an explanation of the

Direct Output. The output may be selected as either

PRE or POST fader. The factory default setting is

POST-FADER, but this may be changed by

moving an internal switch as

shown on the right.

Remove the protective

grommet to gain access to the

switch and move the switch

carefully upwards using a small

screwdriver or the end of a

pencil. It is advisable to turn

the unit off before making this adjustment.

Always check all outputs after adjusting to ensure that switching has been successful.

14 PFL

When the latching PFL switch is pressed, the pre-fade signal is fed to the headphones,

control room output and meters, where it replaces the selected monitor source (MIX,

SUB or 2TK). The PFL/AFL LED on the Master section illuminates to warn that a PFL is

active. This is a useful way of listening to any required input signal without interrupting

the main mix, for making adjustments or tracing problems.

POST-FADE PRE-FADE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

Spirit FOLIO SX mixer User Manual Page 12

Comments to this Manuals

Related products and manuals for Audio mixers Spirit FOLIO SX mixer